Silicone Texture Exterior Paint

APPLICATION FIELD
- It can be used safely in concrete, gas concrete, briquette, brick, plaster and similar mineral surfaces.
FEATURES
- It is resistant to nose and water.
- Extremely resistant to the effects of sunlight and salt-water on the shores.
- The ability to breathe allows the moisture in the wall to be thrown out.
SURFACE PREPARATION
- The surface to be applied must be cleaned from all kinds of grease, dirt, loose and swollen strata,
- In glassy and glossy textures, a surface must be formed to hold the paint.
- The capillary cracks must be filled with an external facing paste.
- Plastered, new and solid surfaces; Filler Primer should be applied as single layer.
- Old painted, very calcified, absorbent, weak etc. On loosely textured surfaces, the floor must be saturated.
- It is necessary to apply primer on cement based decorative plaster used in heat insulation system.
APPLICATION FORM
- Application should be made at least 24 hours after priming.
- It is applied as a single layer without thinning.
- If two coats are desired, the first coats are applied 10-15%, without diluting the second coats.
- The product which is transferred to the surface with a roll or airless spray gun is given a pattern with coral roll.
- Wait at least 12 hours between floors depending on weather conditions.
- With this application, a viscosity of 1.0-1.5 mm is obtained.
- It should be avoided during rainy and humid, extremely windy and hot weather.
DYEABLE AREA
In practice, depending on the surface;
- Single layer, 0.8-1.0 m2 area can be covered with an average 1kg.
- Consumption varies depending on the surface and the pattern.
CONSUMPTION
- Depending on the single layer surface; 25 kg to 20-25 m² area painted.
PACKAGING
- 25 Kg. PE bucket
STORAGE
- Can be stored for 1 year in unopened package, in cool place, protected from direct sunlight and frost